Casablanca Fan Company Brescia Gallery Edition User Manual download pdf (Page 12)

INTELI•TOUCH

♦♦

♦ SINGLE W-32 INSTALLATION

The wall control installs in the same manner as an ordinary light switch, using an existing junction box and wiring. This

controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the

following precautions must be observed:

1. Use only the Casablanca W-32 wall control.

2. Do not use any additional control with your Inteli-Touch

fan (for example, dimmer, fan speed control, etc.).

3. Do not use more than one fan per wall control.

4. No other light fixtures or electrical appliances may be con-

nected on the circuit controlled by the W-32 wall control.

INTELI•TOUCH

♦♦

♦ DUAL W-32 INSTALLATION

W-32 is used to describe either white (-11) or ivory finish.

1. Remove the screws and switch plate from the existing

switch box.

2. Remove the screws holding the switch in the switch box.

3. Pull the existing switch from the switch box to expose the

wire connections.

4. Remove the two wires from the switch.

5. Connect the two wires just removed from the switch to

the W-32 wall control black wire and black/white stripe

wire. Secure these connections with wire nuts.

6. Install the W-32 in the wall box with the two long screws

provided.

7. Install the wall plate with the two color matched screws.

SWAP THESE TWO WIRES

WHEN NECESSARY

(SEE NOTE BELOW)

END

LINE

To control the fan and lights from two locations (a

three-way circuit), use 2 W-32 wall controls.

1. Remove the screws and switch plate from the ex-

isting switch box and the screws holding the switch

in the switch box.

2. Pull the existing switch from the switch box to

expose the wire connections.

3. Determine which wire is connected to the common

terminal of the 3-way switch. (The terminal will be

marked on switch).

4. Remove the wire from the common terminal of the

3-way switch. Connect this wire to the remaining

black/white striped wire on the W-32 control. Se-

cure this splice with a wire nut.

5. Remove the two remaining wires from the 3-way

switch. Connect one of these wires to a black wire

on the W-32 control. Secure the splice with a wire

nut. The remaining wire is to be connected to the

other black wire on the W-32. Secure the splice

with a wire nut.

6. Install the W-32 in the wall box with the two long

screws provided.

7. Install the wall plate with the two short color-

matched screws provided.

8. Installation of the second W-32 control is identi-

cal. Repeat steps 1 through 7.

CAUTION! Ensure power is turned OFF at the breaker

or fuse panel before starting installation.

CAUTION! Ensure power is turned OFF at the breaker

or fuse panel before starting installation.

NOTE: If wall control operation is reversed (fan switch controls

lights and light switch controls fan)

turn off the power at the breaker

or fuse panel, then swap the two W-32 black/white stripe wires.

NOTE: If wall control operation is reversed (fan switch controls

lights and light switch controls fan)

turn off the power at the breaker

or fuse panel, then swap the two W-32 black/white stripe wires.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Comments to this Manuals

No comments

Casablanca Fan Company Brescia Gallery Edition User Manual Page 12

Comments to this Manuals