Casablanca Fan Company ISOTOPE C30G45L User Manual download pdf (Page 13)



1313

W-74

Wall Control

W-74 Wall control PreParation

Wall Plate

Screws (2)

Switch

Mounting

Screws (2)

(4) Wire Cap

WARNING! To avoid possible electrical shock,

make certain that electricity is turned off at the

circuit breaker or fuse box before attempting any

installation or repair procedure

CAUTION! NOT turning the power OFF at the circuit breaker or fuse

box may cause damage to the electronics within the wall control and or

the PC board on the fan.

W-74 Wall control PreParation

















Cover Plate

installing the W-74 Wall control



The wall control installs in the same manner as an ordinary light switch, using an existing wall box and

wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching

operations. For this reason the following precautions must be observed:

single W-74 installation

NOTE: W-74 Wall Control should only be installed on Casablanca's Direct-Touch

Fans.

1. Use only the Casablanca W-74 wall control.

2. Do not use any additional control with your

Direct-Touch

fan (for example, dimmer, or fan

speed control).

3. Do not use more than one fan per wall control.

4. No other light xtures or electrical appliances may

be connected on the circuit controlled by the W-74

wall control.

W-74

Red

White

Blue





1. If you have multiple Direct-Touch

fans, refer to the

section "changing frequency setting" on page 20.

2. Remove the screws and switch plate from the existing

switch box.

3. Remove the screws holding the switch in the switch box.

4. Pull the existing switch from the switch box to expose

the wire connections.

5. Remove the two wires from the switch.

6. Connect the BLACK wire from the POWER SOURCE

that you just removed from the switch to the BLACK/

WHITE STRIP wire on the W-74 wall control. Secure this

connection with a wire nut.

7. Connect the second BLACK wire that you just removed

from the switch to the second BLACK wire on the

located on the back of the W-74 wall control. Secure this

connection with a wire nut.

Figure 1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Casablanca Fan Company ISOTOPE C30G45L User Manual Page 13

Comments to this Manuals

Related products and manuals for Household fans Casablanca Fan Company ISOTOPE C30G45L