Casablanca Fan Company fan c12d4301 User Manual download pdf (Page 6)

CANOPY INSTALLATION

Step 4. Attach the canopy to the crossbar mounting bracket

with three of the 8-32 x 2

” long canopy screws (Screw

Pack B) and lock washers provided with your Casablanca

fan. Tighten using the provided screwdriver until snug

against the ceiling.

NOTE: On sloped ceilings, align the canopy opening with

the top or peak of the room.

 (not to scale)

Canopy

Canopy Hatch

Screw Pack B:

Canopy Screws and



Feed outlet box

wires through

canopy opening

HANGING THE FAN

Step 5a. To hang the motor housing assembly in the canopy,

hold the motor housing assembly ﬁrmly and insert the ball

into the canopy opening. Check that no wires are pinched.

Rotate the motor housing assembly until the slot in the ball

ﬁts into the pin opposite the canopy opening.

Step 5b. Trim excess motor wires, leaving at least 6 inches

above the downrod. Strip

-inch insulation from the end

of each wire using a wire stripper (available at your local

hardware store).

Ball

Slot

Canopy Gasket, Hang-

ing Plate, & Crossbar

Mounting Bracket

Installed

Canopy

Canopy Lock



Canopy

Screws

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Casablanca Fan Company fan c12d4301 User Manual Page 6